Blaupunkt HT6010 Instruction Manual page 9

HT6010
5. Check the technical condition of the cutting blade before each use. Chipped, bent or otherwise
damaged blades create additional danger. In case of any damage to the cutting unit replace it or buy
a new device. Using the power tool with a damaged cutting bar is dangerous for the health and life
of the operator.
6. When cutting, hold the device only by the front handle and the rear handle as the cutting bar may
cut the hidden electrical wires or its power cord.
7. Before starting work, make sure that there are no objects in the hedge that are not part of the plant. -
Wires, fence elements and other foreign objects may damage the cutting blades.
8. Carry the hedge trimmer by the front handle and with the motor turned off. When transporting or
storing fit the provided guard on the cutting element. - Proper operation of the device reduces the
risk of injuries.
9. Do not use the cutting bar as a lever for lifting or moving objects, as well as for shredding plants. -
The device has been designed to perform specific activities. The use of the power tool for purposes
for which it was not intended creates the possibility of hazardous situations.
10. If the power tool falls or is hit hard, it is recommended to contact a service centre.
11. Do not allow yourself for getting into a rut when using the device often. Getting into a rut may
result in ignoring safety principles which may lead to accidents during work.
WEAR PERSONAL PROTECTIVE EQUIPMENT
• Wear safety glasses according to En166
• Use protective masks in accordance with En149
• Use other types of proper personal protective equipment, depending on the type of work involved.
Description of the device
1. Rear handle with power switch
2. Motor housing
3. Front handle with power switch
DEVICE OPERATION
Hand guard.
First, check that the hand guard is correctly installed before starting work. The guard must be firmly
installed so that it is not possible to accidentally slide it off the device. To do so, check the tightening.
-Turning on:
Press simultaneously the power switch (3) of the front handle and the power switch (1) of the rear
handle.
Turning off:
Release any of the power switches (3) or (1). The blade brake will stop the teeth.
Hedge trimming
Select branches with a diameter greater than 20 mm and cut them with secateurs before starting work.
It is recommended to start trimming the hedge from the sides. First move the trimmer from the top to
the bottom, removing the main shoots of the plants, then correct the lines by moving the trimmer
upwards. After trimming the sides of the hedge, you can start trimming its top.
Maintenance.
Do not use solid grease for lubricating the bar. After each use, in addition to cleaning, the cutting blade
also requires light lubrication. Use maintenance oil, thin general purpose lubricating oil or special
spray cleaning and lubricating agents.
Keep grip surfaces dry, clean, and free of oil and grease.
TECHNICAL DATA:
Speed without load 1700 /min
Max. cutting width: 20 mm
Cutting element length: 550 mm
4. Blade
5. Power cord
7