Bend-Pak EXCEL Series Installation And Operation Manual page 4

1. Carefully remove the crating and packing
materials. CAUTION! Be careful when cutting
steel banding material as items may become
loose and fall causing personal harm or injury.
2. Inspect the lift for any signs of concealed
shipment damage or shortages. Remember to
IMPORTANT SAFETY INSTRUCTIONS
1. Read and understand all safety warning
procedures before operating lift.
2. Keep hands and feet clear. Remove hands
and feet from any moving parts. Keep feet clear
of lift when lowering. Avoid pinch points.
3. Keep work area clean. Cluttered work areas
invite injuries.
4. Consider work area environment. Do not
expose equipment to rain . Do not use in damp
or wet locations. Keep area well lighted.
5. Only trained operators should operate this lift.
All non-trained personnel should be kept away
from work area. Never let non-trained personnel
come in contact with, or operate lift.
6. Use lift correctly. Use lift in the proper
manner. Never use lifting adapters other than
what is approved by the manufacturer.
7. Do not override self-closing lift controls.
8. Remain clear of lift when raising or lowering
vehicle.
9. Clear area if vehicle is on danger of falling.
10. Always insure that the safeties are engaged
before any attempt is made to work on or near
vehicle.
11. Dress properly. Non-skid steel -toe footwear
is recommended when operating lift.
12. Guard against electric shock. This lift must be
grounded while in use to protect the operator
INTRODUCTION
Read these safety instructions entirely!
THIS SYMBOL POINTS OUT IMPORTANT SAFETY INSTRUCTIONS WHICH IF NOT FOL-
LOWED COULD ENDANGER THE PERSONAL SAFETY AND/OR PROPERTY OF YOUR-
SELF AND OTHERS AND CAN CAUSE PERSONAL INJURY OR DEATH.
READ AND FOLLOW ALL INSTRUCTIONS IN THIS MANUAL BEFORE ATTEMPTING TO
OPERATE THIS MACHINE.
report any shipping damage to the carrier and
make a notation on the delivery receipt.
3. Check the voltage,
amperage requirements for the motor shown on
the motor plate. Wiring should be performed by
a certified electrician only.
from electric shock. Never connect the green
power cord wire to a live terminal. This is for
ground only.
13. Danger! The power unit used on this lift con-
tains high voltage. Disconnect power at the
receptacle before performing any electrical
repairs. Secure plug so that it cannot be
accidentally plugged in during service.
14. Warning! Risk of explosion. This equipment
has internal arcing or sparking parts which
should not be exposed to flammable vapors. This
machine should not be located in a recessed
area or below floor level.
15. Maintain with care. Keep lift clean for better
and safe performance. Follow manual for proper
lubrication and maintenance instructions. Keep
control handles and/or buttons dry, clean and
free from grease and oil.
16. Stay alert. Watch what you are doing. Use
common sense. Be aware.
17. Check for damaged parts. Check for
alignment of moving parts, breakage of parts or
any condition that may affect its operation. Do not
use lift if any component is broken or damaged.
18. Never remove safety related components
from the lift. Do not use lift if safety related
components are damaged or missing.
phase and proper