Safety Precautions; Hot Surface Warning; Battery Warning - Neousys Technology Nuvo-7168GC Series User Manual

Safety Precautions and Battery Warning

Safety Precautions


Read these instructions carefully before you install, operate, or transport the system.

Install the system or DIN rail associated with, at a sturdy location

Install the power socket outlet near the system where it is easily accessible

Secure each system module(s) using its retaining screws

Place power cords and other connection cables away from foot traffic. Do not place
items over power cords and make sure they do not rest against data cables

Shutdown, disconnect all cables from the system and ground yourself before touching
internal modules

Ensure that the correct power range is being used before powering the device

Should a module fail, arrange for a replacement as soon as possible to minimize
down-time

If the system is not going to be used for a long time, disconnect it from mains (power
socket) to avoid transient over-voltage

By means of a power cord connected to a socket-outlet with earthing connection

This product is intended to be supplied by a Listed Power Adapter or DC power source,
rated 24Vdc, 16A, Tma 60 degree C and 5000m altitude during operation. If further
assistance is required, please contact Neousys Technology

Hot Surface Warning

HOT SURFACE. DO NOT
TOUCH. "ATTENTION: Surface chaude. Ne
pas toucher."

Battery Warning

WARNING!
Components/ parts inside the
equipment may be hot to touch! Please
wait one-half hour after switching off
before handling parts.

Batteries are at risk of exploding if incorrectly installed

Do not attempt to recharge, force open, or heat the
battery

Replace the battery only with the same or equivalent
type recommended by the manufacturer