Philips S Line 37BDL3050S User Manual page 34

37BDL3050S
Manager Email
Specify the destination address to receive the e-mail.
Test
To check if your e-mail settings are correct or not, select 'Send
Test Mail" to send a test e-mail.
FTP
Settings -> Signage Display -> Server Settings -> FTP
Click the checkbox to enable/disable FTP server feature.
After enabling this feature, user can setup account, password
and port number.
(1). Account: The user name to log in the FTP server. The
length of the account name should be ranged from 4 to
20 characters, only [a-z], [A-Z] and [0-9] are allowed to
use.
(2). Password: The password to log in the FTP server. The
length of the password should be ranged from 6 to 20
characters, only [a-z], [A-Z] and [0-9] are allowed to use.
The password are covered by asterisks after setting.
(3). Storage path: The FTP server has access to the internal
storage only. The storage path is unchangeable.
(4). Port: The port number for FTP server. Available port
number ranges from 1025 to 65535, the default setting is
2121. The following port number cannot be used:
8000 / 9988 / 15220 / 28123 / 28124 and SICP network
port (default 5000).
Finally, manually reboot the system to apply FTP settings.
Remote Control
Settings -> Signage Display -> Server Settings -> Remote
Control
Click the checkbox "Enable" to enable or disable the remote
control client service. The default setting is "Enabled". To use
the remote control feature, the device must be bound with
the remote control server.
In the entry field of "Server", input the URL address with
the prefix of "https://". If the device is not bound with the
remote control server, please enter the PIN code provided by
the server.
Bind status:
(1). If the device does not have appropriate network
connection, a message "Network is disconnected" will
appear.
(2). If the device is equipped with network function, but is
not connected to the remote control server, a message
"Server is disconnected" will appear.
(3). If a server is connected, but not bound, a message
"Server is unbinded" will appear.
(4). If the device is bound with the server successfully, a
message "Server is binded" will appear.
(5). If the PIN code is not correct, a message "Error PIN
code" will appear.
SNMP
Enable/Disable SNMP service.
Please refer to the SNMP user manual.
ADB over Network
You can access ADB over a network connection with port
5555.
6.1.2.3. Network Application
Settings -> Signage Display -> Network Application
Proxy
Settings -> Signage Display -> Network Application -> Proxy
Enable the proxy server by clicking the checkbox of "Enable".
User can set up the host IP and port number of the proxy
server. The default setting is "Disable".
22