Schwinn 570E Assembly Manual / Owner's Manual page 46

Condition/Problem
Knocking sound during
machine operation
Squeaking noise
that appears a few
minutes into a workout
and normally will get
progressively worse as
the workout continues
Knocking sound during
machine operation.
Incline assembly sticks/
difficult to adjust
46
Things to Check
Check hardware at
junction between Lower
Handlebar Arm and Pedal
Bolt that connects the
swing arms to the axle
running through the
console mast
Roller squeaking on rail
Check hardware at
junction between Lower
Handlebar Arm and Pedal.
Check position of incline
assembly
Make sure that the alignment tab on the Pivot Sleeve goes into
the slot in the hole. Be sure the Pivot Sleeve extends through
the opposite hole in the joint cover.
Loosen pivot rod bolt slightly until noise goes away. White
lithium grease can also be applied for a temporary fix. Contact
your local distributor for assistance.
Apply silicone lubricant to a dry cloth and wipe the rails to
eliminate roller noise.
Make sure that the alignment tab on the Pivot Sleeve goes into
the slot in the hole. Be sure the Pivot Sleeve extends through
the opposite hole in the joint cover.
Adjust levelers to raise the front of rail assembly until there
is 0.6cm - 1.25cm (1/4" - 1/2") space between the top of the
incline assembly and the main unit shroud.
Solution