Flexcom Communication Ltd
Setting time zone
Set the upload
frequency
Sleep mode
Restart the device
Factory default
setting
Query the position of the device
Description
Call the phone number of the device's SIM card
from your phone. After receiving the call, the
device cancels it and then sends the data back in
an SMS message: latitude and longitude, current
speed, time and link, which, when clicked /
tapped, will display the device's indicator on the
Google map in our phone's browser.
If the device cannot connect to GPS satellites (eg
inside a building or in another shaded area), use
the cell information of the GSM transmission
towers to determine its position (LBS, Location
Based Service). Its accuracy depends largely on
the distance from the towers and the mobile
network coverage.
If you have not previously set up an administrator
phone number, the machine can be called from
any location - otherwise it will only answer calls
from the administrator number.
The device default time
zone is set to GMT + 0.
This is changed (eg in the
case of Hungary, the time
zone is GMT + 1), as
follows.
If you use the service
provider's software
service, the device sends
data to the central server
at specified intervals. You
can set the sending
frequency as follows:
In normal mode, the
device switches to sleep
mode after 10 minutes of
inactivity and inactivity to
save energy. It switches
back to active mode for
any SMS message or
move. Sleep mode can
also be turned on or off via
SMS:
Restart the GPS and GSM
modules of the device.
Reset the device to factory
settings.
Installation and operating instructions (2021/06/09)
timezone123456 value (where value:
érték pl. +1, -2,
0 etc.).
Example: timezone123456 +1 (Hungarian
time zone
setting)
upload123456 időköz (másodperc)
Example: upload123456 60 (sending
data every minute)
Activate: sleep123456
Deactivate:nosleep123456
rst
format
Device response
Device information
20/26
Time Ok
Upload
Ok
Sleep Ok
or
Nosleep
Ok.
Restart
Ok
-
Need help?
Do you have a question about the LK209S and is the answer not in the manual?