Advertisement
6. OPERATION P R O C E D U R E S
6 - 1.Stand - alone operation
* When using the power supply in s t a n d -
alone, simply operate by manipulation of the
panel switches as needed. However, be sure
that the M A S T E R / S L A V E switch is set to
M A S T E R .
6 - 2 .
S e r i a l c o n n e c t i o n ' .
* T w o or more units of the power supply,
can
be hooked
u p : i n series to. achieve in
:
increase in output, voltage... T h e .final' output-
w i l l
be the
sum of the
individual units.. I n this situation, however,
care must be taken that.. the voltage . of
niether of the terminals w i t h respect to the
chassis
GND exceeds
voltage.
* In the case of serial operation of two units
(both same model) ;
a. F o r connection as i n Fig.4, the output
voltage, but output current w i l l be limited
to w i t h i n the value specified for a single
10
-
•
' . •
outputs of
the
the
ground
proof
unit.
b. F o r connection as i n F i g . 5 , w h e r e an
intermediate point is hooked up to ground,
the configuration can be used as a p l u s /
minus power supply.
FigAConneetlon of GND
For
For
Fig.5.
Intermediate point is hooked
up to ground.
positive ground
(dotted line)
negative ground
(solid, line)
E 0 = E 1 + E 2
:
Advertisement
