Table of Contents
Advertisement
6. OPERATION PROCEDURES
6-1. Stand-alone operation
*When using the power supply in stand-alone, simply operate by manipulation
of the panel switches as needed.
switch i s set to MASTER.
6-2, Serial connection
Two or more u n i t s of the power supply can be hooked up i n s e r i e s to
achieve in increase in output voltage. The f i n a l output wi11 be the sum
of the outputs of the individual units. In this s i t u a t i o n , however, care
must be taken that the voltage of niether of the terminals with respect to
the chassis GND exceeds the ground proof voltage.
* In the case of s e r i a l operation of two units (both same model);
a. For connection as in Fig. 4, the output voltage, but output current wi 11
be limited to within the value specified for a single unit.
b. For connection as in Fig. 5, where an intermediate point i s hooked up to
ground, the configuration can be used as a plus/minus power supply.
fConnection of GND
For positive ground (dotted line)
For negative ground (solid line)
E0-E1 + E2
Figure 3.
However, be sure that the MASTER/SLAVE
Intermediate point i s
hooked up to ground.
Figure 4.
11
Advertisement
Table of Contents
