1. MASTER Operation
During M A S T E R Operation, the M A S T E R unit operates in
T A L K ONLY mode, and the S L A V E units operate in LISTEN
ONLY mode.
Therefore, there should be no intermixing of machine types,
and machines of all the same model should be used.
© Interconnecting machines with the connecting cords.
Turn the power switches of all the machines to " O F F " and, us-
ing the connecting cords provided, connect the machines as
shown below. Be sure to connect only IN terminals to O U T ter-
minals, and never connect IN to IN.
Master " 0 "
Slave " 1 "
Slave " 2 "
Up to 5 machines of the same model can be connected.
If more than 5 machines are connected, control may be-
come impossible to achieve.
5. DIRECTIONS FOR USE
Slave " 3 "
Slave "A"
(D Designating the M A S T E R Unit.
1) Turn the POWER switch of PWR # 1 to " O N " while depress-
ing the A key. When the V . A display appears as shown in the
diagram below, release the A key.
2) After POWER ON, the display will continue to appear as above
for about 3 seconds, after which it will appear as shown below.
Addr A
The A D D R E S S NO. ordinarily will have an initial value of
" 1 " , unless it is preset previously to a different value. In
this case, the initial value of the A D D R E S S NO. will be the
preset value.
3) The A D D R E S S NO. of the M A S T E R unit is set to " 0 " via ro-
tary encoder. The A D D R E S S NO. is decreased by rotating the
encoder to the left and increased by rotating to the right. T h e
A D D R E S S NO. can be set fromto any value from "0" to " 2 6 " .
In the case of a
d e f a u l t
parameter
7