Installation - TMC Reef Skim 100nano Instructions Manual

These skimmers come almost fully assembled. For initial setup follow diagram below. If you are re-assembling after carrying
out maintenance/cleaning please follow diagram below to re-assemble correctly.
FULL SKIMMER ASSEMBLY/RE-ASSEMBLY
Please note:
• These models are hang-on skimmers and are for use in-
side the aquarium or sump.
• The sponge helps stop bubbles returning to the aquarium
and should be used as required to help stop bubbles exit-
ing the skimmer.
• To adjust the water level inside the collection cup, gently
twist the collection cup whilst slowly pulling it upwards or
pushing it downwards.
• To attain a wet or dry skim, follow the instructions in "First
and initial operation" on the following pages, adjusting the
water level with the collection cup.
• For further fine tuning of water flow and to achieve opti-
mum skimming performance the water flow of the pump
can also be adjusted.
• Empty and clean collection cup and neck frequently and
regularly clean or replace the sponge to ensure optimum
performance. Failure to do so will result in operating prob-
lems and/or leaks.

INSTALLATION

The Reef Skim 100nano unit is designed to be used inside the
aquarium or sump only. To ensure that the collection cup can
be easily removed for cleaning, allow at least 50mm clear-
ance above the collection cup lid.
Ensure the skimmer and its parts are not touching the sides
of the aquarium or sump as this may cause vibration noise.
GENERAL OPERATING INSTRUCTIONS
Make sure all connections are tightly secured.
Ensure the collection cup is securely and correctly positioned
on the main skimmer body and that the drain plug is in place
or the collection cup drain hose is attached.
Clean and empty the collection cup regularly, and periodical-
ly clean and maintain all other internal parts to ensure the
skimmer works as efficiently as possible.
4