ADTRAN NETVANTA Installation Instructions page 2

NETVANTA HSSI WIDE MODULE
Quick Start Guide
C
OMMANDS
alias <text>
Comment line to provide text describing the interface.
<text> Up to 80 alphanumeric characters
description <text>
Comment line to provide an identifier for this interface
(for example, circuit ID, contact information, etc.)
<text> Up to 80 alphanumeric characters
external-loopback-request
Enables LC (Loopback circuit C) input to control loopback towards the network.
no external-loopback-request
Disables LC (Loopback circuit C) input control of loopback.
loopback {dce | dte | line | remote | none}
Initiates or removes the specified loopback.
dce Loops the physical interface toward the DCE.
dte Commands the DCE to loopback to DTE.
line Commands the DCE to loopback toward the DTE at
the line port.
remote Commands the remote DCE device to loopback for
purposes of testing data communication channels.
none Removes the loopback.
shutdown
Turns off the interface. The no version of this command turns the interface on and
allows it to pass data.
snmp trap link-status
Enables the interface to send SNMP traps when the link status changes and controls
the SNMP variable, ifLinkUpDownTrap Enable. The default is enabled.
Quick Start Guide, 61200934L1-13A, July 2004 Technical Support 1-888-4ADTRAN (1-888-423-8726)
For more detailed documentation, visit us online at
Copyright © 2004 ADTRAN, All Rights Reserved
www.adtran.com
P/N 1200934L1