System Connections - NU Aqua Platinum Series Installation Manual

Installation
6 Stage System Assembly
For Product ID (SKU):
WU-100GPD-NP-ALK, WU-100GPD-WP-ALK
Alkaline Filter Installation
1. Insert one quick connect elbow into the quick
connect fitting on each end of the alkaline filter.
2. Attach the filter housing clips to the post filter.
3.. Clip the alkaline filter into the two housing clips.
UV Filter Installation
For Product ID (SKU):
WU-100GPD-NP-UV, WU-100GPD-WP-UV
O-RING
14
WARNING: Do not forget to install
o-ring on quartz tube
WARNING: Wear gloves when
handling UV bulb. Oil from your hands
can lower the lifespan of the bulb.
1. Attach the filter housing clips to the post filter.
2. Clip the UV filter housing into the two housing
clips. The elbow fitting without the flow sensor
should be above the exit of the post filter.
3. Insert the quartz tube into the filter housing and
slide the rubber o-ring onto the quartz tube.
4. Route the UV ballast bulb plug through the cap
of the housing and connect it to the bulb.
5. Slide the bulb into the quart tube, tighten the
housing cap, and slide the rubber cap over the
housing cap.

System Connections

5 Stage Connections
Product ID (SKU): WU-100GPD-NP, WU-100GPD-WP
J
G
F
A-B Connect red tubing to the feed water adapter to the inlet of the leak detector.
C-D Connect red tubing from the outlet of the leak detector to the water inlet of the first stage.
E-F Connect yellow tubing from the T fitting on the post filter to the tank ball valve.
G-H Connect blue tubing from the outlet of the post filter to the faucet.
I-J Connect black tubing from the flow restrictor to the drain saddle.
A
H
E
I
D
B
C
15