Installation; Feed Water Adapter; Leak Stop Valve - NU Aqua Platinum Series Installation Manual

Installation

Feed Water Adapter

1. Locate and turn off the cold water
valve under your sink. Next turn on the
cold water faucet to drain any remai-
ning water in the line
2. Place a towel below your cold water
valve to catch any remaining water in
the line. Loosen the nut on the water
line where it is attached to the valve.
Feed water adapter can be installed in
either location A or B as illustrated in
the diagram"
3. Wrap the threads of the water valve
and feed water adapter 8-10 times with
teflon tap. using a adjustable wrench
secure the feed water adapter onto the
cold water valve and the water line to
the feed water adapter.
4. Turn the feed water valve to the off
position for the remainder of the
installation process.
5. Insert one end of your red tubing into
the quick connect fitting on your feed
water adapter. Secure in place with a
retaining clip.
WARNINGS:
Only connect to cold water line.
Hot water will damage your system.
1/2" Connection 3/8" Connection
Adapter
Adapter
8
WARNINGS:
Turn the hot water valve off when
installing on a single handed faucet.
Open Closed
Installation
Leak stop valve installation
WARNING:
failure to install Leak Stop Valve will
void Warranty
1. Locate the lowest point within your cabinet or installation
location. Using the included screws, secure your leak stop
valve in this location
2. Locate the red tubing coming from the feed water
adapter and cut it near the location of the leak stopper.
Connect the end of the red tubing coming from the feed
water adapter to the quick connect on the leak stop valve
labeled "in".
3. Take off the plastic wrap off the leak cartridge and place
it inside the leak stop valve as shown.
4. Turn the leak stop valve switch down to put it in the on
position.
Red Tube
Flow Closed
Position
NOTE:
it may be best to insert the cartridge after
the initial startup is complete
Red Tube
Flow Open
Position
9