Filter Housing Install - NU Aqua Platinum Series Installation Manual

Installation
Tank Ball Valve
Do not release pressure
from storage tank unless needed.
NOTE: Tanks come pressurized between 7-10psi
when empty.
1. Apply 8-10 wraps of teflon tank to the threads on
the top of your storage tank.
2. Install your tank ball valve on the tank threads
and tighten by hand.
3. Unscrew the cap from the tank ball valve and
slide it down the yellow tubing.
4. Slide the yellow tubing into the tank ball valve
until it stops. Slide the cap up the yellow tubing and
tighten on to the ball valve by hand.
Tank Thread Tank Valve
12
Tank Stand
Installation

Filter Housing Install

Before installing filters, check o-rings are
properly seated in top of filter housings
and have no visible damage.
1. Remove the plastic wrapper from each filter and
reinsert them back into their housing.
2. While keeping the filters standing vertically in the
housing, attach them to the system by threading it
onto the cap. Refer to diagram for each filters
placement.
3. With all the filter housings installed, use the filter
housing wrench to tighten them fully into place.
Food grade lubricant is used on the o-rings.
Do not clean this off, it's used to prevent
over tightening.
Menbrane Installation
1. Using your housing wrench
loosen the cap.
Elbow Installation
(no pump systems only)
2. Lubricate the double o-rings
with water and insert membrane.
Make sure membrane is fully inserted.
3. Reinstall the housing cap by hand then
tighten with the housing wrench to ensure
a proper seal.
Top Part of the Unit
Filter
Filter
Housing
3rd 2nd 1st
1
2
13