Drain Saddle; Faucet Installation Page - NU Aqua Platinum Series Installation Manual

Installation

Drain Saddle

1. Locate a section on your drain plumbing using the
image above and mark the location with a pen. If the
drain saddle is to be installed on a horizontal section
you must position the hole on top of the pipe.
2. Use a drill with a 1/4" drill bit on the section you
marked. Be careful to drill only through one side of
the pipe.
3. Remove the center of the foam pad included with
the drain saddle. Peel off the adhesive tape on the
back side and attach it to the drain saddle half with
the quick connect fitting. Make sure the center hole
aligns with the hole in the drain saddle.
4. Press the two nuts into the back of the drain
saddle by hand.
10
X OK
OK
X
Mount Drain
WARNING!
X
Saddle at either
OK Never mount
location
there!
5. Slide a small screwdriver through the quick
connect fitting on the drain saddle half and through
the hole drilled in your drain pipe. This will keep the
holes aligned during the installation.
6. While holding the drain saddle in place secure the
back half using the two supplied screws and a screw-
driver. Tighten both screws till the drain saddle is
secure. You may remove the screwdriver holding the
drain saddle in place.
7. Locate your black tubing and insert one end into
the quick connect fitting on your drain saddle.
Installation
Faucet Installation
Drilling
If your sink has a existing hole this can be used for
your faucet. If you have to drill a new hole follow the
steps below.
Granite / Marble / Quartz sinks
Keep the drill bit and hole wet
during the drilling process
1. Locate the section on your countertop to install
your faucet. Using plumbers clay form a ring around
the section you will be drilling. This will be used to
retain water for the drilling process.
2. Fill the ring with water. Using a diamond tip hole
saw drill bit slowly begin drilling. Apply light, and even
pressure and let the drill do the work.
Stainless Sink
1. Locate the section on your countertop to install
your faucet and drill a 1/4" pilot hole. Once comple-
tely drilled through switch to a 1/2" drill bit and re-drill
the same hole.
Tubing Connection
TYPE A
1. Connect the blue tubing to the quick connect
fitting on your faucet adapter.
2. Screw the faucet adapter onto the threaded
faucet stem.
TYPE B
1. Slide the compression nut with the open end facing
upwards down your blue tubing. Follow the nut with
your sleeve.
2. Slide the insert into the opening of your tubing
firmly.
3. Insert your tubing into the faucet stem and tighten
the compression nut to secure it in place. Do not over
tighten.
Open and Closed Position
Closed Open
Base Plate
Rubber Washer Threaded Faucet
Stem
Wing nut
Installation
1. Slide the base plate on the threaded faucet
stem. Insert the faucet into the hole in your
countertop.
2. Under your sink slide the rubber washer on the
faucet stem. Secure the faucet in place by hand
with the wing nut.
TYPE A
Faucer Adapter
1/4" Tube
TYPE B
Insert
Sleeve
Compression Nut
1/4" Tube
11