Snmp Configuration - NXT Power VANGUARD THREE-PHASE 10-40 KVA UPS SNMP Manual

7.2

SNMP Configuration

This page let the Administrator set the local network configuration parameters in
SNMP card.
 Download Root Certificate
Download root certificate from the SNMP card.
 BootP/DHCP
This is the parameter enabling or disabling the Boot Protocol (BootP) /
Dynamic Host Configuration Protocol (DHCP) process. These protocols are
used to obtain a dynamic IP address from a BootP / DHCP server.
 SNMP IP Address
This parameter let the Administrator set the IP address of the SNMP card.
 SNMP Gateway Address
This parameter let the Administrator set the IP address of the gateway of the
SNMP card.
SNMP Subnet Mask

This parameter let the Administrator set the subnet mask of the SNMP card.
 DNS Address
As Administrator, you are required to enter the IPv4 or IPv6 address of your
network DNS server if you entered a Hostname for the Mail Server.
 System Name
The value set in "System name (sysName)" defined in MIB-II. Default value is
SNMP.
 System Contact
The value set in "System manager (sysContact)" defined in MIB-II. Default
value is Technical Support Team.
 System Location
The value set in "System installation place (sysLocation)" defined in
MIB-II. Default value is blank.
 Webpage Title
This parameter let the Administrator set the webpage title.
 History Log Interval(Sec)
This value is the time in seconds to poll Input voltage, Output Voltage, Output
18