Controlling Camera Site Accessories; Lens Control - Panasonic WJ-SX550C Operating Instructions Manual

Contrast and Backlight
Adjustment of LCD Display
The following procedure lets you adjust contrast and back-
light of the controller's LCD display.
Pressing the Direction (A, D, B) buttons at the same
time will display the following on the LCD display.
Contrast
(Zoom) 90(Focus) 99
a) Contrast Adjustment
Pressing the ZOOM TELE/WIDE Control while holding
down the Direction (A, D, B) buttons at the same time
will adjust the contrast of the characters displayed on
the LCD display.
TELE: Increases the character contrast (00
WIDE: Decreases the character contrast (99
b) Backlight Adjustment
Pressing the FOCUS NEAR/FAR Control while holding
down the Direction (A, D, B) buttons at the same time
will adjust the backlight of the LCD display.
NEAR: Increases the backlight brightness (00
FAR: Decreases the backlight brightness (99
5
101
BackLight
99)
00)
99)
00)
Controlling Camera Site
Accessories
Controls for camera site accessories are located on the
right side of the front panel of the System Controller.
Included are Zoom Control, Focus Control, Iris Control,
Preset and Pan/Tilt Controls. Normally combination cam-
eras equipped with the specific feature or a WV-RC100 or
WV-RC150 Receiver are required to utilize these functions.

Lens Control

Confirm that the specified lens with power zoom/focus func-
tions is mounted on the camera. Also confirm that the Lens
Selection Switch (DC/VIDEO) on the camera is set to the
DC position.
Function capabilities vary between cameras. Referring to
the operating instructions of each camera is recommended.
1. Select the desired monitor and camera.
Refer to the Monitor Selection and Camera Selection on
page 100.
2. Press the FOCUS NEAR/FAR Control while observing
the active monitor to adjust the lens focus to achieve a
sharply focused picture.
FOCUS
NEAR
FAR
Pressing the PRESET/AF button will automatically set
the lens focus, if the specified camera with the auto
focus feature is used.
PRESET
3. Press the ZOOM TELE/WIDE Control while observing
the active monitor to adjust the lens zoom to achieve
the desired picture.
Press this control to the TELE position to optically bring
an object closer. Pressing to the WIDE position has the
reverse effect.
ZOOM
TELE
WIDE
AF