Table of Contents
Advertisement
Operation
7. Turn spray/prime valve to PRIME position.
NOTE: Leave spray/prime valve in the PRIME position
until you are ready to spray again.
If you suspect the spray tip or hose is clogged or that
pressure has not been fully relieved after following the
steps above, VERY SLOWLY loosen tip guard retaining
nut or hose end coupling to relieve pressure gradually,
then loosen completely. Clear hose or tip obstruction.
See Clearing Tip Clog, page 15.
Setup
1. Connect Graco airless hose to sprayer. Tighten
securely.
10
2. Connect other end of hose to gun.
3. Tighten securely.
4. Remove spray tip and guard from gun.
ti2702a
ti2703a
333402A
Advertisement
Table of Contents
