Zennio MINiBOX 25 Technical Documentation

Multifunction actuator with 2 outputs (16A) and 5 analog/digital inputs
ZIO-MN25
FEATURES
 2 outputs configurable as:

1 shutter channel.

2 individual outputs*.
*Suitable for capacitive loads, maximum 140 µF.
 5 analog/digital inputs.
 Manual output operation with push button and LED
status indicator.
 Logical functions included.
 Output timing facilities.
 Total data saving on power failure.
 Size 67 x 90 x 35 mm (2 DIN units).
 Integrated KNX BCU.
 DIN rail mounting (EN 50022), through pressure.
 Possibility to connect different phases in adjoining outputs.
 Conformity with the CE directives (CE-mark on the right side).
1. Output status LED indicator
5. Programming/Test LED
Programming/test button: short press to set programming mode. If this button is held while plugging the device into the KNX bus, it enters the safe
mode. If this button is held for more than 3 seconds, the device enters the test mode.
Programming/Test LED: programming mode indicator (red). When the device enters into safe mode, it blinks (red) every half second. The manual
mode is indicated by the green color. During the start-up (reset or after KNX bus failure) and if the device is not in safe mode, it starts a blue blinking
sequence.
GENERAL SYSTEM SPECIFICATIONS
CONCEPT
Type of device
Voltage (typical)
Voltage range
Voltage
KNX
Maximum
supply 29VDC (typical)
consumption
24VDC
Bus connection
External power supply
Operation temperature
Storage temperature
Operation humidity
Storage humidity
Complementary characteristics
Protection class
Operation type
Device action type
Electrical stress period
Degree of protection
Installation
Response on KNX bus failure
Response on KNX bus restart
Operation indication
Weight
PCB CTI index
Housing material
(1)
Maximum consumption in the worst case scenario (KNX Fan-In model)
© Zennio Avance y Tecnología S.L.
2. Output control button
6. Programming/Test button
DESCRIPTION
Electric operation control device
29VDC SELV
21...31VDC
(1)
Typical TP1 bus connector for rigid cable 0.80mm Ø
No
from 0ºC to +55ºC
from -20ºC to +55ºC
5 to 95% RH (no condensation)
5 to 95% RH (no condensation)
Class B
II
Continuous operation
Type 1
Long
IP20, clean environment
Independent device to be mounted inside electrical panels with DIN rail (EN 50022)
Data saving and relays action according to parameterization.
Data recovering and output status change according to parameterization.
Programming LED indicates programming mode (red) and test mode (green). Output
status LED indicators reflect current output state.
117.5g
175V
PC FR V0 halogen free
Edition 4
7
1
6
2
5
3
Figure 1. MINiBOX 25
3. Analog/Digital inputs
mA
7.5
10
Further information www.zennio.com
MINiBOX 25
Technical Documentation
4
4. KNX connector
7. Outputs
mW
217.5
240
Page. 1 / 2