Robern UPLIFT TECH CABINET Instructions Manual page 12

SECTION 4 - FINAL ASSEMBLY
9. With the cabinet properly installed, slide the cabinet door up to the open position. Position the Side Kit on the side of the cabnet
and attach the side kits using the four screws (203-1451) provided with the Surface Mount Kit. Cover screws with caps (SS672).
9
10. The height of the shelves can be adjusted in 1" (25mm) increments. Install shelf clips as shown in channels/holes in interior side of
cabinet.
11. Install the shelves into the channel of the clear shelf clip by sliding shelf into clip from front.
10
© 2019 Robern, Inc. 701 N. Wilson Ave. Bristol, PA 19007 U.S.A.
800.877.2376 www.robern.com
Installation instructions
11
12
Part no. 209-1319-rA rev. 08/21/19
Uplift Tech Cabinet