Table of Contents
Advertisement
Initializing the hard
disk
Installing additional memory
Kit contents
After you install the hard disk and power on the printer, you may be
prompted to initialize the new hard disk drive. If so, follow the directions
below:
1
From Ready or Ready(Sleep), press the Menu/Exit
button to enter the Setup menus.
2
Press the Continue/Forward button until Hard Disk
appears. Follow the instructions on the LCD.
The following section explains how to install a 16 or 32 MB SDRAM
(Synchronous Dynamic Random Access Memory) DIMM (Dual In-line
Memory Module) on the KX-P8420.
To install the SDRAM DIMM (illustrated below) you will need to do the
following:
•
Remove the printer controller board from the back of the printer.
•
Install a 16 or 32 MB SDRAM DIMM in either of the two empty SDRAM
slots on the printer controller board.
•
Replace the printer controller board.
IMPORTANT:
•
To avoid electric shock ensure your hands are dry before touching the
printer's power plug.
•
SDRAM DIMM
CAUTIONS:
•
Do not drop or bend the SDRAM DIMM.
•
Do not touch the connector edge of the SDRAM DIMM.
•
Protect the SDRAM DIMM from static electricity by keeping it in its anti-
static package until you are ready to install it.
•
Avoid exposing the SDRAM DIMM to direct sunlight, high temperatures,
or humidity.
Options
The shape of a
SDRAM DIMM is
subject to change.
199
Advertisement
Table of Contents
