CO2 Meter TON-0007 User Manual

Tongdy CO2 Monitor with Relay (TON-0007)
U s e r M a n u a l
U s e r M a n u a l

Specifications

Power supply
Consumption
CO2 sensor
CO measuring range
2
Accuracy@25℃(77℉),2000ppm
Response time
Warm up time for each turning-on
6 LED lights
On/Off output for control CO2 level
Operation conditions
Storage conditions
Dimensions
Net weight
Installment standard
Housing and protection class
Standard approval
Version

Mounting and Wire Connection

 Notice the supply power voltage of the detector: 24VAC. Do not install the detector on voltages
higher than marked on the detector.
 Firstly, prepare a flat head screwdriver and put it inside of the hole on the top of the detector
housing following step 1, and then open the cover from step 2 to step 4 in next page fig.1.
 Mount the wall plate first, dimensions see next page fig. 2.
Connect wires to terminal strips, (see fig. 3).

Follow step 5 to step7 in fig. 4 to close the cover.

24VAC/VDC
1.5 W Max ; 0.8 W avg
Infrared Sensor with lifetime of 15 years
ABC Logic Self Calibration (default: effective)
0～2,000ppm
±40ppm + 3% of reading or ±75ppm (whichever is greater)
<2 minutes for 90% step change
2 hours (first time) 2 min (operation)
1 st green light on as CO2 measurement≤600ppm
1 and 2 green lights on as CO2 measurement>600ppm and≤800ppm
st nd
1 yellow light on as CO2 measurement>800ppm and≤1,200ppm
st
1 st and 2 nd yellow lights on as CO2 measurement>1,200ppm and≤1,400ppm
1 st red light on as CO2 measurement>1,400ppm and≤1,600ppm
1 st and 2 nd red lights on as CO2 measurement>1,600ppm
<240VAC/30VDC 3A switching current (resistance load),
0~50℃(32~122℉); 0~95%RH, non condensing
0~50℃(32~122℉);
100mm×80mm×28mm (H X W X D)
180g
65mm×65mm (2"×4") wire box
PC/ABS fire proof material with IP30
CE-Approval
TSM-CO2-1A1R-ST02_65 (SE)
1