Advertisement
Table of Contents
Inlet Port
Outlet Port
1.
Unpack the device, ensure it is charged
and ready to use.
2.
Power on and wait for the device to
complete it's warm up cycle.
3.
Use the included tubing and flow
regulator to connect your CM-1650
to your gas source. Please note, the
tubing should be connected to the
inlet port (right hand side). Ensure
the regulator is in the fully open
position (1.0 LPM).
*Failure to use the included regulator could
result in serious damage to the device.*
QUICK
START
GUIDE:
CM-1650
PORTABLE CO2
WELDING GAS
ANALYZER
4.
Use the up and down directional buttons
to scroll through mixture options and
select your CO2 blend to be analyzed,
then press Enter.
5.
Connect your flow regulator to the
source, open the regulator fully to
apply gas to activate the device.
Secure your tubing and you are ready
to begin analyzing.
Watch Our Quick Start Video Here
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for CO2 Meter CM-1650
Summary of Contents for CO2 Meter CM-1650
- Page 1 CO2 blend to be analyzed, then press Enter. Use the included tubing and flow regulator to connect your CM-1650 Connect your flow regulator to the to your gas source. Please note, the source, open the regulator fully to tubing should be connected to the apply gas to activate the device.
- Page 2 TROUBLE SHOOTING: CM-1650 PORTABLE CO2 WELDING GAS ANALYZER Symptom / Issue Possible Cause / Resolution Make sure the power supply is connected properly and that there is Device does not power ON power from the outlet. Ensure the device’s internal batteries are charged.
Need help?
Do you have a question about the CM-1650 and is the answer not in the manual?
Questions and answers