Product Type; Identification; 3.1.1 Hardware Identification - Magtek DynaFlex II Instructions Manual

3 - Product TypeProduct Type
3

Product Type

DynaFlex II products include USB communications, magnetic stripe readers (MSR), contact chip card
readers (ICCR), and contactless card readers (CTLS). DynaFlex II products may also be purchased with
an embedded barcode reader (BCR).
DynaFlex II products can be used as desktop or handheld devices. The Kiosk version uses a back cover
intended for secure mounting, suitable for use in an unattended environment. All are approved as Smart
Card Reader (SCR) devices, adhering to PCI PTS POI v6.2 requirements.
Usage in any other environment will invalidate the approval.
3.1

Identification

3.1.1 Hardware Identification

To find important product identification, look on the printed product label on the bottom of the device as
shown in Figure 3-1 below. The device may need to be temporarily detached from stands or surfaces to
view the label.
The printed label includes the following elements of device identification information, shown by the
numbered callouts below in Figure 3-2:
1) Product name
2) PCI Hardware Identifier ("HW")
The label also contains other supporting information about the device.
DynaFlex II| Smart Card Reader | PCI PTS POI v6.2 Security Policy
Do not remove or alter this label.
Figure 3-1 - DynaFlex II Products Device Label Location
Figure 3-2 - DynaFlex II Device Label
Page 7 of 17 (D998200573-10)