Table of Contents
Advertisement
Installing a Terminal Cap
OPERATING INSTRUCTIONS
SAVE AND PASS THESE OPERAT-
ING INSTRUCTIONS AND THE
INSTALLATION INSTRUCTIONS TO
SUBSEQUENT OWNERS. THE
INFORMATION PROVIDED IS
INTENDED TO NOTIFY AND WARN
THEM ABOUT MAKING UNSAFE
FUTURE MODIFICATIONS SUCH AS
THE ADDITION OF SHELVES OR
THE USE OF UNAUTHORIZED
PARTS AND REPAIRS.
HAND PROTECTION IS RECOM-
This fireplace is intended to operate as a supplemen-
tal heat source for a single room. It is not designed
to function as a primary heat source for a structure.
Fireplaces, as well as other woodburning appliances,
have been used safely for many years. It has been
our experience that most problems are caused by
improper installation and operation of the unit. Make
certain that installation and operation of the fireplace
system is in accordance with these instructions.
4-99
Figure 22
NOTICE:
CAUTION:
EDGES ARE SHARP.
MENDED.
EM SERIES WOODBURNING FIREPLACE
It is extremely important that the fire be super-
vised whenever the fireplace is in use. It is also
recommended that an annual inspection be per-
formed on the fireplace system to determine if
the flue system needs to be cleaned, or as in
the case of any appliance, if minor repairs are
required to maintain the system in top operating
condition.
INTENDED USAGE.
place is intended for use with either solid fuel
(firewood) or a decorative gas appliance that
has been tested and listed to the Standard for
Decorative Gas Appliances for Installation in
Vented Fireplaces, ANSI Z21.60. When oper-
ating your fireplace, the flue damper must
be in the open position.
This fireplace was not tested and listed for use
with an unvented gas log heater. Do not install
an unvented gas log heater in this fireplace and
operate it with the flue damper in the full closed
position unless the unvented gas log has been
specifically tested and listed for use in this fire-
place by Underwriters Laboratories Inc. Use of
an unvented gas log heater in this factory-build
fireplace may create a fire hazard that can
result in a structure fire.
DO NOT OPERATE THIS FIREPLACE WITH
THE FLUE DAMPER IN THE CLOSED POSI-
TION. COMBUSTION PRODUCTS MUST
VENT UP THE CHIMNEY SYSTEM TO PRE-
VENT CARBON MONOXIDE POISONING,
AND TO PREVENT HOT COMBUSTION
GASES FROM CONTACTING AND OVER-
HEATING COMBUSTIBLE SURFACES.
FAILURE TO OPERATE THIS FIREPLACE
WITH THE DAMPER IN THE OPEN POSI-
TION MAY RESULT IN ASPHYXIATION OR
A STRUCTURE FIRE.
FIREPLACE OPERATION DOES RE-
QUIRE AIR. DO NOT TAKE AIR
FROM OTHER FUEL BURNING
APPLIANCES WHICH CAN RESULT
IN IMPROPER VENTING (SMOK-
ING) OR AIR DILUTION. ALWAYS
PROVIDE ADEQUATE MAKE-UP
AIR.
20
This factory-built fire-
WARNING!
CAUTION:
31316A
Advertisement
Table of Contents
