Table of Contents
Advertisement
EM SERIES WOODBURNING FIREPLACE
LISTINGS AND CODE APPROVALS
The EM Series fireplace system has been tested and
listed in accordance with UL127 and ULC S610
Standards, and has been listed by Underwriters
Laboratories Inc. for installation and operation in the
United States and Canada as described in these
Installation & Operating Instructions.
The Model EM Series fireplace has been tested and
listed for use with the optional components given on
page 4. These optional components may be pur-
chased separately and installed at a later date.
THIS HEAT-N-GLO FIREPLACE AND ITS COMPONENTS ARE DESIGNED TO BE
INSTALLED AND OPERATED AS A SYSTEM. ANY ALTERATION TO OR
SUBSTITUTION FOR ITEMS IN THIS SYSTEM, UNLESS ALLOWED BY THESE
INSTALLATION INSTRUCTIONS, WILL VOID THE UNDERWRITERS LABORATORIES
LISTING AND MAY VOID THE PRODUCT WARRANTY. IT MAY ALSO CREATE A
HAZARDOUS INSTALLATION. READ THROUGH THESE INSTRUCTIONS
THOROUGHLY BEFORE STARTING YOUR INSTALLATION AND FOLLOW THEM
DESCRIPTION OF THE FIREPLACE SYSTEM
The HEAT-N-GLO fireplace system consists of the following:
1.
Fireplace/Integral Grate
2.
Hearth Extension
Optional components include:
1.
Glass Doors
NOTE: Illustrations throughout these instructions
reflect "typical installations" and are for design
purposes only. Actual installation may vary slight-
ly due to individual design preferences. However,
minimum and maximum clearances must be main-
tained at all times.
The illustrations and diagrams used throughout
these installation instructions are not drawn to
scale.
4-99
WARNING!
CAREFULLY THROUGHOUT YOUR PROJECT.
However, installation of an Outside Air Kit and
Junction Box will require significant reconstruction,
and should be installed at the time of the initial fire-
place installation.
Check with your local building Code agency prior to
installing this fireplace to ensure compliance with local
Codes, including the need for permits and follow-up
inspections. If any assistance is required during
installation, please contact your local dealer or
Heat-N-Glo, a Division of Hearth Technologies Inc.,
20802 Kensington Blvd., Lakeville, MN 55044.
3.
Chimney System
4.
Chimney Termination Cap
2.
Outside Combustion Air System
Tools and Building Supplies
Normally Required:
Tools:
Building Supplies:
Saw
Hearth Extension Material
Pliers
Wall-finishing Material
Hammer
Framing Material
Phillips Screwdriver
Fireplace Surround
Tape Measure
Caulking Material
Plumb Line
Level
Electric Drill and Bits
Framing Square
3
31316A
Advertisement
Table of Contents
