Husqvarna P 524X Operator's Manual page 12

To engage and disengage the Roll Over Protection
Structure (ROPS)
• Remove the 2 pins that hold the ROPS and fold it
rearwards to disengage. Engage the ROPS in the
opposite sequence.
WARNING:
instructions for the ROPS and the safety
belt.
• Do not use the safety belt if the ROPS is
disengaged.
• Always use the safety belt when the ROPS is
engaged.
• Make sure that the ROPS is correctly attached and
not damaged.
12
Obey the following
To adjust the vibration damping units on the ROPS
The ROPS has 4 vibration damping units that prevent
vibration and noise from the ROPS.
1. Disengage the ROPS. Refer to
disengage the Roll Over Protection Structure
(ROPS) on page 12 .
2. Turn the upper vibration damping units until there is
no play in the ROPS.
3. Engage the ROPS. Refer to
disengage the Roll Over Protection Structure
(ROPS) on page 12 .
4. Turn the lower vibration damping units until there is
no play in the ROPS.
5. Tighten the counter nuts.
To engage and
To engage and
1902 - 003 - 09.02.2023