Table of Contents
Advertisement
To give the system a voice command, press
'
and wait for the audible signal indicat-
ing that the voice recognition system is ac-
tivated; you can now give the command in
your normal voice - not too quickly, but with-
out interruptions. When the system recog-
nises the command, it will respond or per-
form an action.
The voice commands are divided into level
1, level 2 and level 3.
When a valid* level 1 voice command is
said the system is ready to recognise 2nd
level voice commands; when a valid 2nd lev-
el voice command is said, the system is ac-
tivated to recognise 3rd level voice com-
mands.
If the user gives a valid * 1st level voice
command, the submenu for that command
remains activated until a voice command
that leads to another level is given or the in-
teraction is interrupted; the same rule ap-
plies to the lower levels (2 and 3).
* Valid means that the voice command is part of the Blue&Me™ system vocabulary and is therefore recognisable at a given level.
For a list of all available voice commands,
refer to the LIST OF AVAILABLE VOICE COM-
MANDS chapter.
To listen to the last message given by the
'
system again, press
for more than 1 sec-
'
ond or press
briefly and say "Repeat".
It is possible that the hands-free system will
provide spoken information.
A voice announcement is a voice message
spoken directly by the system. To end a
&
voice announcement, press
'
press
and say "Cancel".
A vocal interaction is an exchange of com-
munication/commands between the hands-
free system and the user. To start a voice in-
'
teraction, press
and give a command.
To stop an interaction and start a new one,
'
press
at any time during the interaction
and give a voice command.
&
To end an interaction, press
will hear a signal indicating that voice recog-
nition has been deactivated.
The help function can provide you, at any
time, with a list of commands available in
the level you are at. To use the help system,
say "Help", listen to the list of commands
available and decide which command you
want to give the system.
Adjust the volume to the level that is best
for you with the vehicle in motion. To adjust
the preset Blue&Me™, volume, refer to
the "SPEECH VOLUME function" section in
the car radio instruction manual. To tem-
porarily adjust the volume of an ongoing
/ESC or
call, press + or – or turn the car radio knob.
At the end of the call, the volume will return
to its original level.
You can also press + or – to adjust the vol-
ume of a vocal announcement while it is be-
ing said by Blue&Me™.
Remember that, to interrupt a vocal an-
nouncement, you can press
during a vocal interaction and provide a new
/ESC. You
voice command.
'
at any time
15
Advertisement
Table of Contents
