4.3
Measuring ranges
4.3.1
Measuring ranges for thermoresistor
Introduction
The following tables contain the digitized analog values for the measuring ranges of the
analog input modules.
Since the binary representation of the analog values is always the same, these tables
contain only a comparison of the measuring ranges with the units.
Measured values in the event of wire break dependent on enabled diagnostics for resistance
measurement
The following extensions exist for the measuring ranges Temperature sensor Pt xxx
Standard and Climatic, Ni xx Standard and Climatic, Cu 10 Standard and Climatic:
Table 4-3
Measured values in the event of wire break dependent on enabled diagnostics
Format
Parameter assignment
"Wire break" diagnostics enabled
S7
•
"Wire break" diagnostics disabled
•
"Overflow/underflow" diagnosis
•
enabled
"Wire break" diagnostics disabled
•
"Overflow/underflow" diagnosis
•
disabled
2AI RTD HF analog electronic module (6ES7134-4NB51-0AB0)
Manual, 05/2007, A5E01076876-02
Measured values
Decimal
Hexadecimal
32767
7FFF
H
-32767
8000
H
-32767
8000
H
Analog value representation
4.3 Measuring ranges
Notes
Diagnostics message "wire break"
•
Measured value after leaving the
•
undershoot range
"Value under low limit" diagnostic
•
message
Measured value after leaving the
•
undershoot range
25