Table of Contents
Advertisement
Installation
TO BE NOTED BEFORE INSTALLATION
All fan coils are delivered packed in a cardboard box.
The sticker on the outside of the packaging identifies
the model, size, fit of the water connections to the fan
coil and all accessory parts contained in the packaging.
To avoid damage or contamination of the heat exchang-
er, the unit should not be unpacked until immediately
before installation. To remove the packaging, open the
underside of the box and pull it off from above. Follow-
ing installation, it is advisable to cover the fan coil with
the packaging until all construction work has been com-
pleted. Do this as follows:
3
2
REMOVING THE SIDE PANELS
To remove the plastic housing on the side, proceed as
follows:
Open the plastic cover...
Undo the safety screws...
Carefully move the plastic sheet to the side while
slightly lifting the underside...
83018200bEN – Translation of the operating manual
We reserve the right to modify technical specifications without prior notice.
1
© ait-deutschland GmbH
MOUNTING ON THE WALL
Before fixing the unit onto the wall, check the following:
·
the wall must be sufficiently load-bearing;
·
the fan coil must be accessible on all sides for
maintenance;
·
there must be no hanging objects or other items
in front of the unit, which could impede the air in-
let or outlet;
·
air distribution must be possible in the whole
room.
Install the unit as follows:
Draw on the positions of the fixing holes as shown
in the sketched example...
all dimensions in mm
GK... 6
A
B
GK... 11
GK... 21
558
558
818
538
538
798
9
Advertisement
Table of Contents
