Table of Contents
Advertisement
CONDENSATE PUMP (GKP)
The pump is used to dispose of condensate if the waste-
water pipe is located higher. The condensate pump is
equipped with an alarm function and switches off the
GK(R) if the quantity of condensate produced is greater
than the quantity that can be removed.
CONDENSATE PUMP TECHNICAL DATA
Max. delivery rate:
Max. delivery head:
Max. intake depth:
Voltage:
Max. power consumption: 10 W
1 Spacer 3 cm
2 Washers
3 Hose clips
4 Condensate pump
5 Condensate hose
6 Plastic hose 19 cm
7 Screws 3.9 x 50
CONDENSATE PUMP (GKP) INSTALLATION
INSTRUCTIONS
DANGER!
Risk of fatal electric shock! Before installing the
condensate pump, safely disconnect the system
from the power supply and secure it from being
switched back on!
IMPORTANT
Clean the condensate tray before installing the
condensate pump.
IMPORTANT
Install the condensate pump so that it is safe
from contact (touch).
83018200bEN – Translation of the operating manual
We reserve the right to modify technical specifications without prior notice.
8 l/h
8 mWC
2.5 mWC
230 V/50 Hz – 110 V
© ait-deutschland GmbH
IMPORTANT
Immersion or installation in wet rooms is not
allowed.
IMPORTANT
Do not insulate the pump.
Remove the condensate pump and the mounting
rail from the packaging...
1 Condensate pump
2 Mounting rail
Fix the condensate pump onto the side of the unit
on which the hydraulic connections are located...
First, screw the right side of the mounting rail onto
the unit...
Then push the condensate pump onto the mount-
ing rail...
11
Advertisement
Table of Contents
