Touch Sensitivity - Panasonic Toughbook CF-Y5LWEZABM Reference Manual

Using the Touch Pad
To begin using the Touch Pad utility again:
(Start) and input [c:\util\touchpad] in [Start Search], and then press Enter.
Click
A
Right-click [setup] in [touchpad] folder and click [Run as Administrator].
B
If there are two or more "setup" files, right-click the file whose [Type] is [Application].
3
Conduct steps
C
Click [Virtual Scrolling], remove a check mark from [Enable vertical scrolling] and [Enable horizontal scrolling], then
D
click [OK].
Click [OK] at [Mouse Properties].
E
Click or
F
When or
Click [General settings], add a check mark for [Use Touch Pad function], then click [OK].
G
Adjusting the Sensitivity when Touching the Touch Pad
Adjust [PalmCheck] and [Touch Sensitivity] using the following procedure:
1
Click (Start) - [Control Panel] - [Mouse] - [Device Settings].
2
Click the device name (e.g., Synaptics TouchPad) in [Devices], then click [Settings].
3
Double-click [Sensitivity], then click [PalmCheck] or [Touch Sensitivity].
4
After making the adjustment, click [OK].
PalmCheck
™
When operating the keyboard, if your hand touches the Touch Pad unintentionally causing the cursor to move, adjust the
sensitivity using "PalmCheck™."
• By dragging slide bar to the [Maximum] position, you can prevent the cursor from moving unintentionally.
• By dragging slide bar to the [Minimum] position, you can enable the cursor to move even with a light touch of the palm
on the Touch Pad.

Touch Sensitivity

When operating the Touch Pad, if your finger touches the Touch Pad, unintentionally causing the cursor to move; or if the
cursor does not move even when you move your finger on the Touch Pad, adjust the sensitivity using the "Touch Sensitiv-
ity".
• By dragging slide bar to the [Heavy Touch] position, the cursor will only move with a strong touch on the Touch Pad.
• By dragging slide bar to the [Light Touch] position, the cursor will move even with a light touch on the Touch Pad.
4
to ( page 10).
on the notification area, and click [Settings].
is not displayed: page
1
6, step -A
11