Removing And Refitting The Door - Whirlpool W6 OS4 4S1 H BL Quick Start Manual

REMOVING AND REFITTING THE DOOR

1. To remove the door, open it fully and lower the
catches until they are in the unlock position.
a
b
2. Close the door as much as you can. Take a firm hold of
the door with both hands – do not hold it by the handle.
Simply remove the door by continuing to close it while
pulling it upwards at the same time until it is released
from its seating. Put the door to one side, resting it on a
soft surface.
~15°
a
b
3. Refit the door by moving it towards the oven,
aligning the hooks of the hinges with their seating and
securing the upper part onto its seating.
4. Lower the door and then open it fully. Lower the
catches into their original position: Make sure that you
lower them down completely.
a
b
Apply gentle pressure to check that the catches are in
the correct position.
"CLICK"
5. Try closing the door and check to make sure that it
lines up with the control panel. If it does not, repeat the
steps above: The door could become damaged if it does
not work properly.
EN
13