Table of Contents
Advertisement
Safety
Introduction
Installation Overview
This equipment is intended to be installed by a person or persons with the basic
knowledge of installing similar equipment. Contact Waterous with questions
about installing the equipment. The installation may require the following tasks
and abilities:
• Locating, drilling, and cutting
features into the apparatus.
• Connecting electronic devices.
• Do not install the equipment if you are not familiar with the tools and skills
needed to safely perform required procedures—proper installation is the
responsibility of the purchaser.
Determining Cable and Wire Routing
Use the Wiring Best Practices document, available at www.waterousco.com, as
a guide to select and route wiring for your application.
Preparing for the Installation
Read and understand all the installation instructions before installing the
equipment. Prepare a suitable, well-lit area, and gather all the necessary tools
before you begin the installation.
NOTICE
Before Operation
• Read and understand all
the instructions provided.
• Check all fluid levels
and replenish if necessary.
• Remove all shipping plugs
and install the operation
plugs or caps.
Product Overview
• Configuring and calibrating the
system.
• Final testing.
Installation
Optional Equipment
Be aware that the installation instruction may include optional equipment not
included in your application.
Hose and Tubing Requirements
Use the following specifications to locally source hoses and tubing for your
application. This is only required if priming pump and priming valve are not
installed at the factory.
Tubing
Locally source a tube of the appropriate length with the following
specifications:
• Outer diameter: 3/4-inch
• Inner diameter: 1/2-inch to 5/8-inch
• Color: Black, ultraviolet resistant
• Durometer: 61A minimum, must be compression fitting compatible
• Must withstand 25-inch Hg of vacuum
• Must be capable of servicing water
• Connection: 3/4-inch compression fitting
Hose
Locally source a hose of the appropriate length with the following
specifications:
• Outer diameter: 1-1/8-inch
• Inner diameter: 5/8-inch
• Must have 2 fiber braids with oil resistant jacket
• Minimum working pressure: 200 psi
• Minimum burst pressure: 1000 psi
• Must withstand 25-inch Hg of vacuum
• Connection: 3/4-inch pipe fitting
|
25
56
Operation
Maintenance
Advertisement
Table of Contents
