Wireless Communication - Panasonic Toughbook CF-74JDMBD2M Reference Manual

Troubleshooting (Advanced)
Disc Operation
Cannot eject a disc.
The disc tray does not close.
Other disc operation problems.
Network
Cannot connect to network.
Cannot check the computer's MAC
address.
Wireless Communication (Only for model with wireless LAN/Bluetooth/wireless
WAN)
Cannot connect to network.
Access point is not detected.
Turn on the computer.
To remove a disc when the computer is powered
off, insert a pointed object (e.g., the bent-out tip of
a paper clip, or the tip of a pencil or ballpoint pen)
into the emergency hole (A). Pushing it completely
to the end will free the tray so that it can be pulled
out. (The position of the emergency hole differs
depending on the drive.)
Do not touch the eject button when closing the tray.
Use another drive or media.
Set [LAN] / [Modem] to [Enable] in the [Advanced] menu of the Setup Utility
( page 67).
Follow the steps below.
Click [start] - [All Programs] - [Accessories] - [Command Prompt].
A
Input [ipconfig /all], and press Enter.
B
Write down the 12-digit string of alphanumeric displayed in the
C
"Physical Address" line of the LAN or the wireless LAN (only for model
with wireless LAN).
Input [exit], and press Enter.
D
Slide the wireless switch to turn on the wireless devices.
Set the device ([Modem] / [Wireless LAN] / [Bluetooth] / [Wireless WAN]) to
[Enable] in the [Advanced] menu of the Setup Utility (
Restart the computer.
Confirm that / /
If / / is not displayed on the notification area, turn on the wireless
communication.
is displayed on the notification area.
79
page 67).