LAN
Enabling the Power On by LAN function
The computer automatically turns from off to on when the computer is accessed from the network server via the internal LAN
port.
1
Select [Allow] in [Power On by LAN] in the [Advanced] menu of the Setup Utility (
67).
2
In [Caution], press
3
Press
, and then select [Yes] and press
F10
4
Log on to Windows as an administrator.
5
Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] -
[Device Manager] - [Network adapters] and double-click [Marvell Yukon 88E8055 PCI-E
Gigabit Ethernet Controller], and then click [Advanced].
6
Click [Wake From Shutdown] in [Property] and select [On] in [Value], and click [OK].
NOTE
The computer may accidentally turn on if the linkage status is changed. To prevent the accidental startup, make the
setting by the following steps.
Click [start] - [Control Panel] - [Performance and Maintenance] - [System] - [Hardware] - [Device Manager] -
A
[Network adapters], and double-click [Marvell Yukon 88E8055 PCI-E Gigabit Ethernet Controller], and then click
[Advanced].
Click [Wake Up Capabilities] in [Property] and select [Magic Packet] in [Value], and click [OK].
B
If you forcibly shut down Windows, the Power ON by LAN function will not work.
.
Enter
.
Enter
54
page