Observator Instruments MET-LINK Manual page 14

2. Connect the MET-LINK sensor to the Maximet module by matching the pin.
3. Press on the MET-LINK interface module button and notice the blue Light-Emitting Diode (LED)
indicator is flashing. If you cannot see the blue flashing indicator light, it means the MET-LINK interface
module is not powered.
Note: In the event where the indicator is not lighting up, ensure that the MET-LINK interface module
has enough battery (refer to the "Charging the battery" section 7.2 of this manual) and ensure that
the long term storage switch inside the Bluetooth module is on.
LED status
Flashing blue
Flashing green
Flashing red, blue, green
No LED
Flashing green, red, blue, off
4. Run the application go to the chapter 8: "Android application interface" of this document.
Manual | MET-LINK
Status: Final | Not confidential
Colour
Bluetooth available for pairing
Device is paired
Battery is charging or charged
MET-LINK interface module off
MET-LINK is being powered off
Blue LED is on
Meaning
Page 14 | 31
V20200225