Installation; Installing The Sensor For The First Time - Observator Instruments MET-LINK Manual

7

Installation

7.1 Installing the sensor for the first time

To install the Android application on your smartphone, use the following link, download and install the
".Apk file" (for smartphones):
1. Unscrew the back cover of the MET-LINK interface module using the hex-key provided. Switch on the
"long term storage switch" using a small screw driver/pin.
Connect the Li-Ion battery to the MET-LINK interface module (normally installed when provided). If not,
please follow the instructions described in the chapter 10: "Maintenance & calibration" section 10.1:
"Battery replacement".
Note: If storing the wireless interface for more than six months, please power off the device.
Manual | MET-LINK
Status: Final | Not confidential
Download & install MET-LINK application
Long-term storage
switch is on
Page 13 | 31
V20200225