Unitron Moxi V-R Manual page 26

Notice 1
This device complies with Part 15 of the FCC Rules and with RSS-
210 of Industry Canada. Operation is subject to the following two
conditions:
1) this device may not cause harmful interference, and
2) this device must accept any interference received, including
interference that may cause undesirable operation.
Notice 2
Changes or modifications made to this device not expressly approved
by Sonova AG may void the FCC authorization to operate this device.
Notice 3
This device has been tested and found to comply with the limits for
a Class B digital device, pursuant to Part 15 of the FCC Rules and
ICES-003 of Industry Canada. These limits are designed to provide
reasonable protection against harmful interference in a residential
installation. This device generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this device does cause
harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the device into an outlet on a circuit different from that to
which the receiver is connected
• Consult the dealer or an experienced radio/TV technician for help
46
Radio information of your wireless hearing aid
Antenna type
Operation frequency
Modulation
Radiated power
Bluetooth
®
Range ~1m
Bluetooth
Profiles supported
Emissions Compliance Electromagnetic environment
Test
Group 2
RF emissions
Class B
CISPR 11
Harmonic Complies
emissions
Voltage Complies
fluctuations /
flicker
emissions
Resonant loop antenna
2.4 GHz – 2.48 GHz
GFSK, Pi/4 DPSK, GMSK
< 2.5mW
4.2 Dual-Mode
HFP (Hands-free profile), A2DP
guidance
The medical device uses RF energy
only for its internal function.
Therefore, its RF emission are very
low and are not likely to cause any
interferences in nearby electronic
equipment.
47