Samsung SHP-DP920 User And Reference Manual page 5


Z-Wave plus info (V2)
- Z-Wave Plus Version : 02
- Role Type : LSS (Listening Sleeping Slave)
- Node Type : Z-Wave Plus Node

Manufacturer Specific (V2)
- Device ID Type : 01(Serial Number)
- Device ID Data Format : 01 (Binary)
- Device ID Data Length Indicator : 16
- Device ID : XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX XX

Version (V2)
- Z-Wave Protocol Library Type : 03
- Z-Wave Protocol Version : 04
- Z-Wave Protocol Sub Version : 05
- Firmware 0 Version : 01
- Firmware 0 Sub Version : 03
- Hardware Version : 01

Door Lock (V2)
- support Unsecure(0x00), Secure(0xFF)
Note : When using 'Operation_Set' command, lock will execute 'Unsecure(0x00)' then
perform 'Auto Re-lock' if door is not open.
When using
'Operation_Set' command. (take about 2 seconds)

User Code (V1)
- Lock will accept maximum 130 pin codes that are 4-10 digits in length.
① Supported Users : 130
② User Type : Number, Card (Key Tag), Fingerprint, Bluetooth
⋅ Card (Key Tag), Fingerprint, Bluetooth : Cannot be registered through Z-Wave
③ ID Range
⋅ Number : 1 ~ 130
'Operation_Get'
command, lock can response after executing