HP ProCurve Switch 2900yl-24G Access Security Manual page 220

Traffic/Security Filters
Filter Types and Operation
ProCurve(config)# filter source-port named-filter web-only drop 2-26
ProCurve(config)# filter source-port named-filter accounting drop 1-6,8,9,12-26
ProCurve(config)# filter source-port named-filter no-incoming-web drop 7,10,11
ProCurve(config)# show filter source-port
Traffic/Security Filters
Filter Name
-------------------- + -------------------- + --------------------------
web-only
accounting
no-incoming-web
ProCurve Switch 2626(config)#
ProCurve(config)# filter source-port 2-6,8,9,12-26 named-filter web-only
ProCurve(config)# filter source-port 7,10,11 named-filter accounting
ProCurve(config)# filter source-port 1 named-filter no-incoming-web
ProCurve(config)#
8-10
Defining and Configuring Example Named Source-Port Filters. While
named source-port filters may be defined and configured in two steps, this is
not necessary. Here we define and configure each of the named source-port
filters for our example network in a single step.
| Port List
| NOT USED
| NOT USED
| NOT USED
Applying Example Named Source-Port Filters.
Once the named source-port filters have been defined and configured we now
apply them to the switch ports.
The show filter command shows what ports have filters applied.
Ports and port trunks using the
filter. When NOT USED is
displayed the named source-port
filter may be deleted.
| Action
| drop 2-26
| drop 1-6,8-9,12-26
| drop 7,10-11
Lists the ports
and port trunks
dropped by the
filter. Ports and
port trunks not
shown are
forwarded by the
filter.
To remove a port
or port trunk from
the list, update
the named
source-port filter
definition using
the forward
option.