Panasonic Toughbook CF-19AHJAX1M Reference Manual page 73

Fingerprint Reader
More Advanced Security
You can increase your computer's security level by setting the BIOS level described in this section.
Performed by the Computer Administrator.
1
Register the Supervisor Password.
You have to register the Supervisor Password to proceed to the next step.
If you have already registered the Supervisor Password, you can skip this step, and move on to step
If you have not done this, have enrolled your fingerprint using Protector Suite, and have already made Power-on
Security effective, after step B, your fingerprint authentication will be necessary.
Turn on or restart the computer.
A
Press F2 or Del while [Panasonic] boot screen is displayed soon after the computer starts the startup
B
procedure.
Select the [Security] menu.
C
Select [Setup Supervisor Password], and press Enter.
D
Enter your password in the [Create New Password], and press Enter.
E
The password will not be displayed on the screen.
Use only the upper horizontal row of numeric keys (including spaces) to input your password.
The case (upper/lower) is distinguished.
You cannot use Ctrl to input a password.
Enter your password again in [Confirm New Password], and press Enter.
F
2
Set the High Security Level.
Select [Fingerprint Security], and press Enter.
A
Select [Security mode], and select [High].
B
• Default setting: Simple
Press Esc to close the sub-menu.
C
Press F10, select [Yes], and press Enter to exit the Setup Utility.
D
NOTE
In the [High] security mode, you have to enter the Supervisor or User Password even after fingerprint authentication.
In the [Simple] security mode, you do not have to enter the Supervisor or User password after fingerprint authentication.
To use the Power-on Security feature, enable it in [Control Center] (
Change the setting of [Power-on Security] in the Setup Utility only in the specific case such as the Finger print device
cannot be used.
page 72).
73
2
.