Table of Contents
Advertisement
Model Number:
Controller
Max. Gate weight
Motor Protection Switch
Hold to run function
Automatic function
IR-Sensor
Automatic close
Flashing Light
Safety edges
Emergency Stop
Radio
External Light switching function
Traffic light with Red-Light
Technical Data
Voltage
Phases
Frequency
Current (nominal)
Power
Motor Protection Switch
Torque (max.)
Gear Reduction
Duty Cycle Rating
Temperature Range
IP-Rating
Gate Speed
Sprocket
Weight
INSTALLATION OF DRIVE
The base for the drive can either be concreted or, if
appropriate, made of steel.
The concrete plinth needs to be of an appropriate size
(approx. 80cm long x 80cm wide x 100cm deep).
Notice: Precisely determine the height of the plinth
(motor mounting socket) and the distance from the gate
prior to installation. You are advised to work as
precisely as possible.
MOUNTING MOTOR AND GEAR UNIT
The weight of the gate should not be borne by the cog
wheel! Position the drive via the adjustment holes such
that its location vis-à-vis the rack bar complies with the
installation dimensions.
MOUNTING RACK BAR
The easiest way to fit the rack bar is to first place it on
the motor's drive cog, disengage the motor and, by
pushing the gate further with the rack bar, screwing the
bar bit by bit firmly in position. In this way, you ensure
that the rail bar engages with the cog wheel in an
optimum manner. While doing this, do not forget to
mark each fixing point.
Notice: Steel racks are recommended (320001 = 1m)
For
gates
with
weights
recommended to use two steel racks.
The tooth racks should be fitted as shown with an
overlap from rack to rack. For two rack mounting the
M8 screw must be replaced with a longer type to suit
the application.
SLY3500
none
(kg)
5500kg
yes
no
no
no
no
no
no
no
no
no
no
415V
3
50Hz
1,79A
0,75 kW
adjust to 2.1
150Nm
1:40
60%
-25/+55°C
IP55
10m/min
90mm / Module 4
41kg
above
3.000kg
SLY3500E1
SLY3500E2
EWS2T
CB400
5500kg
3500kg
yes
yes
no
yes
no
yes
no
yes
no
yes*
no
yes*
no
yes*
possible
yes*
external
external
no
yes*
no
yes*
* requires optional ZM-SKS-B plug in card
it
is
Advertisement
Table of Contents
