Cleaning And Maintenance - LEITZ ProfilCut Instruction Manual

Risk of injuring due to parts flying off!
Tools with cracked bodies or deformed seatings of the cutting parts have to be taken out
of service.
Repairing such tools is not allowed!
Risk of tool breakage!
Do not use a deformed tool!

6. Cleaning and maintenance

6.1 Cleaning and maintenance of woodworking tools
Tools must be regularly cleaned of chips and resin built-up and protected against
corrosion. Regular cleaning increases tool life and reduces energy consumption.
Wear safety gloves!
Risk of injury due to sharp cutting edges!
Use suitable cleaning agents that do not attack / corrode the various components to clean
the tools.
Tools with aluminium bodies or coated bodies require special cleaning agents.
The date sheet of the cleaning agent manufacturer must be observed as to the suitability
of the cleaning agent, the permissible concentration, exposure time, and temperature!
Risk of damage!
Examples of suitable cleaning and corrosion protection agents:
Pre-cleaning:
Linix-Radical resin remover (for aluminium and steel)
General cleaning:
Sur-Tec 143 or Avilub METACLEAN 788 (for aluminium and steel)
Sur-Tec 194 (only for steel)
Corrosion protection:
Ballistol or WD-40 (maintenance oil)
18 11/2019 ID.524811 V3.0