Attaching The Training Wheels - Jetson Light Rider JLRM16-PBK Manual

REAR WHEEL
REAR AXLE

Attaching the Training Wheels*

1.2
(*IF NEEDED)
YOU WILL NEED THE 15MM WRENCH.
1. LAY THE BIKE FRAME ON ITS SIDE.
2. ON THE SIDE OF THE REAR WHEEL THAT IS FACING
UPWARDS, LOOSEN AND REMOVE THE AXLE NUT
BY TURNING IT COUNTERCLOCKWISE WITH YOUR
FINGERS OR THE 15MM WRENCH.
3. REMOVE THE WASHER UNDERNEATH THE AXLE
NUT BUT DO NOT REMOVE THE SILVER PLATE
UNDERNEATH THE WASHER. SET THE NUT AND
WASHER ASIDE.
WASHER
15MM WRENCH
AXLE NUT
13