Table of Contents
Advertisement
Fortress 1700 DT/TA
Do not spray or pour water on scooter.
Be careful with water near the electronic system.
Upholstery: do not dry clean, iron or spin dry.
7
Troubleshooting
If your Fortress 1700 DT or TA will not function, even though the batteries are
fully charged, check the following points before getting in touch with your
dealer.
1.
Check that all battery clamps are securely in place.
2.
Check the free wheel lever to ensure it is in the BRAKE ENGAGE position
(not in free wheel position).
3.
Check if the automatic circuit breaker button has popped out. If it has,
reset the circuit breaker by pushing the button back in position. If it pops
out again, contact your dealer.
7.1 Troubleshooting table
If your scooter is not working, or is not working as it should, go through the
following list of possible problems before contacting your dealer. You may be
able to solve the problem yourself.
Possible cause
The jack key is not properly
•
inserted into the jack key
receptacle.
The connectors in the motor
•
compartment are not plugged
into the controller properly, or
they are loose.
The battery clamps are not
•
fastened properly.
The scooter is in free-wheel
•
position.
The automatic circuit breaker
•
has popped out.
Action
Put the jack key into the
•
receptacle properly.
Check the connectors and
•
make sure they are
plugged into the controller
properly.
Check the battery clamps.
•
Move the free wheel lever
•
into the BRAKE ENGAGE
position, then remove and
re-insert the jack key to
reset the scooter.
See 'Circuit breaker'
•
Push the automatic circuit
•
breaker back in and reset
scooter with jack key.
Action to
be taken
by
Yourself
Dealer
Yourself
Yourself
Yourself
51
Hide quick links:
Advertisement
Table of Contents
