Installation Instructions - Sharp R-28A0(B) Operation Manual

Table of Contents

Advertisement

1. Remove all packing materials from the oven cavity ( do not remove the waveguide cover ) , and the feature
sticker from the outside of the door, if there is one. Check the unit for any damage, such as a misaligned
door, damaged door seals around the door or dents inside the oven cavity or on the door. If there is any
damage, please do not operate the oven until it has been checked by a SERVICE CENTRE APPROVED
BY SHARP and repaired, if necessary.
2. Accessories provided
1 ) Turntable 2 ) Roller stay 3 ) Operation manual and Cooking Guide
3. This oven can be installed in the locations indicated by the following "checkmarks".
Installation location
Installation image
Presence or absence of
check mark
Standard conformity number
This oven is designed to be used on a counter top, on a shelf or in a cabinet.
It should not be installed in any area where excessive heat and steam are generated, for example, next to
a conventional oven unit. The oven should be installed so as not to block ventilation openings. When the
oven is mounted on a kitchen countertop, on a shelf or in a cabinet,allow a space of at least 10 cm on the
top, 5 cm on both sides and at the rear of the oven for adequate air circulation. Additionally, when
installing in a cabinet or on a shelf, the minimum inside dimension of the cabinet or a shelf should be
713mm ( W ) × 606mm ( H ) × 448mm ( D ) . This oven must be operated with cabinet door open.
Do not built-in the appliance under the countertop or any other appliances.
WARNING: The electrical outlet must be readily accessible so that the unit can be unplugged easily in an emergency.
4. Neither the manufacturer nor the distributors can accept any liability for damage to the machine or
personal injury for failure to observe the correct electrical connecting procedure.
The A.C. voltage must be single phase 230 – 240V, 50Hz.
5. This appliance must be earthed.
6. Operate the oven from a general purpose domestic outlet. If a generator is used, do not operate the oven
with non-sinusoidal outputs.

INSTALLATION INSTRUCTIONS

Countertop
On a Shelf
( AS/NZS60335 )
5
In a Cabinet
Built-In

Advertisement

Table of Contents
loading

Table of Contents