Setting The Clock; Microwave Cooking - Sharp R-28A0(B) Operation Manual

SETTING THE CLOCK

This is a 12 hour clock. To set the clock
1. Press CLOCK once. "00:00" will display and the hour figure will flash.
2. Press NUMBER PAD to input the time, ( Time range should be 1:00-12:59 ) .
3. Press CLOCK to confirm the setting.
Note:
• During the setting of the clock, if STOP/CANCEL is pressed or there is no operation for 1 minute, the
setting will be unsuccessful.

MICROWAVE COOKING

Enter the Cook Time
Press the NUMBER PAD to input cooking time.
The cook time can be programmed for up to 99 minutes 99 seconds ( 99:99 ) .
Select the Power Level
Press POWER once, "PL10" will display, indicating 100% Power Level.
Press POWER continuously until the required power level is displayed.
There are 11 power levels to choose from - 100%, 90%, 80%, 70%, 60%, 50%, 40%, 30%, 20%, 10%, 0%.
Refer to the table below on how to select the right power level.
Microwave Power Level Guide
Level 10
Power 100% 90%
Display PL10
Start Cooking
Press START/+30 SEC to start cooking.
Example: 10 minute cooking time at 50% power.
1. Press the NUMBER PAD of 1, 0, 0, 0 in order; "10:00" will display.
2. Press POWER once, "PL10" will display. Press POWER continuously until "PL5" displayed.
3. Press START/+30 SEC to start cooking, the time will count.
Notes:
• To stop the microwave before the end of the cook time, press STOP/CANCEL.
• If the door is opened during cooking/defrosting to stir or turn the food, the cook time on the display stops
automatically. The time will start to count down again once the door is closed and START/+30 SEC is
pressed.
9 8 7
80% 70%
PL9 PL8 PL7
6 5 4
60% 50% 40%
PL6 PL5 PL4
8
3 2 1
30% 20% 10%
PL3 PL2 PL1
0
0%
PL0