Installations/Connections; Install On Ceiling - Panasonic WV-NS202A Installation Manual

Panasonic wv-ns202a: installation guide
Hide thumbs Also See for WV-NS202A:
Table of Contents

Advertisement

Installations/Connections

Caution:
ONLY CONNECT THIS TO 12 V DC CLASS 2 POWER SUPPLY.
The following are descriptions of how to install the camera.
The camera can be installed on a ceiling and can be placed on a desktop by placing the camera upside-down.
Before starting the installation/connection, prepare the required devices and cables.
Before starting the connection, turn off the power of the devices including the camera and the PC or disconnect from
the DC 12 V power supply.

Install on ceiling

When installing the camera on a ceiling, there are two methods; wiring through a hole in the ceiling ( page 13) and
wiring through a cable guide (unnecessary to make a hole in the ceiling) ( page 17).
Important:
• Prepare four fixing screws (M4 or M6) to be used to mount the provided mount bracket according to the material
of the area where the camera mount bracket is to be installed. Do not use wood screws and nails.
When installing on concrete ceiling: Fix with anchor bolts (M6).
(Recommended tightening torque: 5.0 N·m {51 kgf·cm})
• Required pull-out capacity of a single screw/bolt is 196 N {20 kgf} or more.
• If a ceiling board such as plaster board is too weak to support the total weight, the area shall be sufficiently rein-
forced or the optional ceiling mount bracket for the camera, WV-Q105, shall be used. When using an optional
mount bracket or inner cover, refer to the operating instructions of the bracket in use.
• When using an outdoor housing to install the camera, use an optional inner cover (WV-Q153).
• Remove the cover film from the transparent part of the dome cover after the installation is complete.
• When using an optional mount bracket, refer to the operating instructions of the bracket in use.
• When using a DC12 V power supply, it is necessary to fabricate the cable end. ( page 16)
<When using the optional mount bracket WV-Q105>
Safety wire angle
Anchor bolt (Procured locally)
Safety wire
Camera mount bracket
WV-Q105 (sold separately)
Mounting screws (4 pcs.)
(WV-Q105 supplied)
Ceiling board such as plaster board
Decorative cover (standard accessory)
Camera
13

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents