Panasonic WV-NS202A Installation Manual page 10

Refer to the network operating instructions (PDF)
for further information.
Indication label
Refer to the indication label placed on the surface of
the unit as to the indications of equipment classification
and power source, etc.
PoE (Power over Ethernet)
Use a PoE hub/device that is compliant with
IEEE802.3af standard.
Router
When connecting the camera to the Internet, use a
broadband router with the port forwarding function
(NAT, IP masquerade).
Refer to the Network Operating Instructions (PDF) for
further information about the port forwarding function.
Radio disturbance
When the camera is used near a TV/radio antenna, or a
strong electric field or magnetic field (such as near a
motor or a transformer), images may be distorted and
noise may be produced.
Installing place
Contact your dealer for assistance if you are unsure of
an appropriate place in your particular environment.
• Make sure that the installation area is strong
enough to hold the camera, such as a concrete
ceiling. When the installation area is not strong
enough, reinforce and strengthen it or use an
optional mount bracket (WV-Q150C, WV-Q150S,
WV-Q151C, WV-Q151S or WV-Q105).
• When using an outdoor housing to install the cam-
era, use an optional inner cover (WV-Q153).
Avoid installing in the following locations.
• Locations where it may get wet from rain or water
splash (not only outdoor)
• Locations where a chemical agent is used such as
a swimming pool
• Locations subject to steam and oil smoke such as
a kitchen
• Locations near flammable gas or vapor
• Locations where radiation or x-ray emissions are
produced
• Locations subject to strong magnetic field or radio
waves
• Locations where corrosive gas is produced
• Locations where it may be damaged by briny air
such as seashores
• Locations where the temperature is not within
–10 °C - +50 °C (14 °F- 122 °F).
• Locations subject to vibrations (This product is not
designed for on-vehicle use.)
• Locations subject to condensation as the result of
severe changes in temperature
Be sure to remove this product if it is not in use.
10
Mounting screws
Only the fixing screws are provided to fix the camera
with the provided mount bracket. It is necessary to pro-
cure screws or bolts to mount the camera. Prepare
them according to the material and strength of the area
where the camera is to be installed. The screws and
bolts must be tightened with an appropriate tightening
torque according to the material and strength of the
installation area.
Refresh interval
Image refresh interval may become slow depending on
the network environment, PC performance, shooting
subject, access number, etc.
MPEG-4 Visual patent portfolio license
This product is licensed under the MPEG-4 Visual
patent portfolio license for the personal and non-com-
mercial use of a consumer for (i) encoding video in
compliance with the MPEG-4 Visual Standard ("MPEG-4
Video") and/or (ii) decoding MPEG-4 Video that was
encoded by a consumer engaged in a personal and
non-commercial activity and/or was obtained from a
video provider licensed by MPEG LA to provide MPEG-
4 Video. No license is granted or shall be implied for
any other use. Additional information including that
relating to promotional, internal and commercial uses
and licensing may be obtained from MPEG LA, LLC.
See http://www.mpegla.com.
Distributing, copying, disassembling, reverse compil-
ing, reverse engineering, and also exporting in violation
of export laws of the software provided with this prod-
uct, is expressively prohibited.